A-A-54279
Metric products. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, providing they fall within the tolerance specified using conversion tables contained in the latest revision of Federal Standard 376, and all other requirements of this document are met. If a product is manufactured to metric dimensions and those dimensions exceed the tolerances specified in the inch/pound units, a request should be made to the contracting officer to determine if the product is acceptable. The contracting officer has the option of accepting or rejecting the product.
Regulatory requirements.
Federal Food, Drug and Cosmetic Act. If the product covered by this document has been determined by the U.S. Food and Drug Administration to be under its jurisdiction, the offeror/contractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of Federal Food, Drug and Cosmetic Act, as amended, and regulations promulgated thereunder. In addition, the offeror/contractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of all other applicable Federal, State, and local statutes, ordinances, and regulations.
Recovered materials. The offeror/contractor is encouraged to use recovered materials in accordance with Federal Acquisition Regulation Subpart 23.4 to the maximum extent practical.
Preservation, packaging, packing, labeling and marking. Unless otherwise specified, preservation, packaging, and packing shall be to a degree of protection to preclude damage to containers and/or contents thereof under normal shipping conditions, handling, etc. involving shipment from the supply source to the receiving activity, plus reshipment from receiving activity, and shall conform to applicable carrier’s rules and regulations. Intermediate and exterior package quantities and labeling and marking shall be as specified in the contract and/or order.
NOTE: The following National Stock Number is covered by this document:
|
6640-00-559-1389 |
FUNNEL, COMMON, LABORATORY, SMOOTH |
ASTM Standard E438 can be obtained from American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business